Giới thiệu DIY Hot End Kit 0.4mm Nozzle 30mm Thermistor & Aluminum Heater Block
DIY replacement kit universal for damaged 3D printer hot end, special for Anet A2 & A8 printer. Pre-wired NTC3950 thermistor, 100K ohm, 1.1m in length. 12V 40W 6*20mm cartridge heater. Aluminum heater block. 0.4mm output nozzle. 6mm diameter external thread extruder throat, 30mm length, suits for 1.75mm filament. Resistance: at 25 Celsius=100K ohm Working Temperature Range: -40 Celsius+300 Celsius Voltage: 12v Power: 40w colour:red Material:Stainless steel + aluminum + brass size:Cable Length: Approx. 1.1m Diameter: 1.75mm Length: 30mm External Thread Diameter: 6mm Nozzle Material: Brass Input Diameter: 1.75mm & 3mm Output Diameter: 0.4mm Wire Length: Approx. 1m Package Contents: 1 * Hot End KitOnly the above package content, other products are not included. Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.